It is detected
but it seems to stall the raspistill/vid programs.# vcgencmd get_camera
supported=2 detected=2
When used alone, I get this message
After different tests to narrow down the cause, I see that when I replace the camera itself (same stereopi, same module, same ribbon) by the other one of the kit, all works fine.# raspistill -o /media/DCIM/test.jpg -t 1
Camera control callback cmd=0x4f525245mmal: No data received from sensor. Check all connections, including the Sunny one on the camera board
I checked the connector between the camera chip and the board module (what seems to be named the sunny connector) and all is fine. Nothing looks bad on the camera board visually.
I wanted to exchange the camera chips between the modules, but the cable is too short for a safe experiment.
Any idea of what I can verify?