Camera control callback cmd=0x4f525245 mmal: No data received from sensor.
Posted: Sat Nov 27, 2021 6:55 pm
I have the StereoPi V2 with all the elements installed. When I connect the power I connect to the web page and I do not see anything from the cameras.
I used this commanad to stop the server:
root@stereopi:/opt/Cosmostreamer-NG# ./stop.sh
When use:
root@stereopi:/opt/Cosmostreamer-NG# raspistill -cs 0 -o test.jpg -v
the camera dont shown anything and shown tis message at the end:
Camera control callback cmd=0x4f525245
mmal: No data received from sensor.
Check all connections, including the Sunny one on the camera board
I have checked the connections several times.
Whats is the problem?
When the server is on: root@stereopi:/opt/Cosmostreamer-NG# ./run.sh
the message is:
mmal: mmal_vc_component_enable: failed to enable component: ENOSPC
mmal: camera component couldn't be enabled
mmal: main: Failed to create camera component
mmal: Failed to run camera app. Please check for firmware updates
Should I do some kind of configuration that I don't know about?
Thanks.
I used this commanad to stop the server:
root@stereopi:/opt/Cosmostreamer-NG# ./stop.sh
When use:
root@stereopi:/opt/Cosmostreamer-NG# raspistill -cs 0 -o test.jpg -v
the camera dont shown anything and shown tis message at the end:
Camera control callback cmd=0x4f525245
mmal: No data received from sensor.
Check all connections, including the Sunny one on the camera board
I have checked the connections several times.
Whats is the problem?
When the server is on: root@stereopi:/opt/Cosmostreamer-NG# ./run.sh
the message is:
mmal: mmal_vc_component_enable: failed to enable component: ENOSPC
mmal: camera component couldn't be enabled
mmal: main: Failed to create camera component
mmal: Failed to run camera app. Please check for firmware updates
Should I do some kind of configuration that I don't know about?
Thanks.