Page 1 of 1

HDMI female dismount

Posted: Mon Sep 16, 2019 7:42 pm
by Joseph Phillips
I plugged cameras in, SD in, HDMI, all that. Monitor showed two distributions to choose from, I was smiling. I was ready to begin a project. Then the female HDMI connector, along with male end of HDMI cord, detached from board. Monitor is blank. I removed the snap-down module and the cameras and bagged them up. Can I please get a replacement StereoPi board? I have everything else from the kit? I only got to use it for three minutes.

Re: HDMI female dismount

Posted: Tue Sep 17, 2019 6:11 am
by Realizator
Hi Joseph,
Could you please attach a photo of your board after this problem?
UPD> Joseph, I’ve write you an email to the address you’ve used for registering on this forum. Please answer me :)