StereoPi (CM3+ Lite) stopped working - LED blinks
Posted: Sat Oct 17, 2020 6:41 pm
Hi,
after a short while, my brand new StereoPi V0.9 with CM3+ Lite stopped working.
I was still on the SLP image (two PiCam V2, worked great) when at some point it just froze.
I tried to reboot, but it would not come up again. Onstead, the LED closest to the "USB Slave" jumper stayed on for some seconds after boot and then starts blinking (goes dark 4 times in a row at ca. 4Hz, than stays solid for about 2 seconds, then repeats)
I burned new images, tried several SD cards, changed the power supply, snapped in-and-out the CM....... still not booting (HDMI stays dark btw)
Any suggestions? I would appreciate any input...
Regards
Kai
after a short while, my brand new StereoPi V0.9 with CM3+ Lite stopped working.
I was still on the SLP image (two PiCam V2, worked great) when at some point it just froze.
I tried to reboot, but it would not come up again. Onstead, the LED closest to the "USB Slave" jumper stayed on for some seconds after boot and then starts blinking (goes dark 4 times in a row at ca. 4Hz, than stays solid for about 2 seconds, then repeats)
I burned new images, tried several SD cards, changed the power supply, snapped in-and-out the CM....... still not booting (HDMI stays dark btw)
Any suggestions? I would appreciate any input...
Regards
Kai