Hi all,
I feel bad using the forum as a help ticketing system, but seems to be the way to go.
I have a v0.9 Stereopi from the original CrowdSupply buy which I'm finally trying to get going. I have tried both the v0.2.3 SLP and a current Raspbian install with the dt-blob. Cameras in all cases are Raspi Cam V2 NOIR,
In both cases:
1. "vcgencmd get_camera" returns "supported=2 detected=1"
2. "raspistill -cs 0 -v" appears successful, "raspistill -cs 1 -v" returns:
mmal: Could not select camera : error 3
mmal: main: Failed to create camera component
mmal: Failed to run camera app. Please check for firmware updates
3. I've swapped the (camera+cable) sets and had the same behavior.
Further options for debugging?
Many thanks, everyone.
Camera 1 not detected
- Realizator
- Site Admin
- Posts: 900
- Joined: Tue Apr 16, 2019 9:23 am
- Contact:
Re: Camera 1 not detected
Hello ammarburg ,
Yes, the forum is the right place to go
Sorry for this issue with your board. I see you did a lot of troubleshooting steps. If you have this error with the "-cs 0" option in both cases (before and after camera swap), then it looks like a second CSI-2 connector issue. I can suggest you a board replacement.
I sent you an email (to the address you used to register on this forum). Please answer.
Yes, the forum is the right place to go
Sorry for this issue with your board. I see you did a lot of troubleshooting steps. If you have this error with the "-cs 0" option in both cases (before and after camera swap), then it looks like a second CSI-2 connector issue. I can suggest you a board replacement.
I sent you an email (to the address you used to register on this forum). Please answer.
Eugene a.k.a. Realizator
Re: Camera 1 not detected
Hi Eugene,
Just confirming I replied to the email earlier this week. Let me know if it didn't come through.
Just confirming I replied to the email earlier this week. Let me know if it didn't come through.
- Realizator
- Site Admin
- Posts: 900
- Joined: Tue Apr 16, 2019 9:23 am
- Contact:
Re: Camera 1 not detected
Hi ammarburg,
Replacement confirmed by Crowd Supply, and they will ship it to you in a few days!
I also replied to your email.
Replacement confirmed by Crowd Supply, and they will ship it to you in a few days!
I also replied to your email.
Eugene a.k.a. Realizator
Re: Camera 1 not detected
Hate to harp on this, but I have not had any communication from Crowd Supply. Is a replacement still in the works?
Thanks!
Thanks!