Page 1 of 1

stereoPi upgraded case

Posted: Wed May 22, 2019 8:31 pm
by NiamoR42
Hello,

perhaps it could help you : I did some modifications on the current stereoPi case.
you can find the cad and freecad project here : https://www.thingiverse.com/thing:3633970

Image

I remove these volumes on the current design :
Image
Image

result (I have to improve my 3D printer...) :
Image
Image

You are able to use screw & bolt to fix the card =)
Image
NiamoR42

Re: stereoPi upgraded case

Posted: Thu May 23, 2019 9:49 am
by Realizator
NiamoR42, wow, that's great, thank you for sharing!
By the way, are you planning to add vent holes at the bottom, or you have no temperature issues? Are you using CM3 or CM3+?

Re: stereoPi upgraded case

Posted: Thu May 23, 2019 11:10 am
by NiamoR42
Realizator wrote:
Thu May 23, 2019 9:49 am
NiamoR42, wow, that's great, thank you for sharing!
By the way, are you planning to add vent holes at the bottom, or you have no temperature issues? Are you using CM3 or CM3+?
why not, I'll see it by using the stereoPI.
it's true that the glue gun was good but, with the temperature, the cover takeoff. I may need to use others screw.