Fresh Raspbian Image Start-up

S.L.P. image questions, stereoscopic video livestream and recording, stereoscopic photo capture etc.
Post Reply
RoggieC
Posts: 2
Joined: Wed Jun 23, 2021 10:11 pm

Fresh Raspbian Image Start-up

Post by RoggieC »

Hello,

I am currently trying to both cameras to work on the Stereopi, but I keep receiving the error: “Cannot read camera info, keeping the defaults for 0V5647.” I got the SLP working, but now I am trying to run from a fresh Raspbian image. I put the dt-blob.bin into the Boot partition as instructed on the Wiki, but the error keeps occurring.

Any ideas on why this is happening?

User avatar
Realizator
Site Admin
Posts: 704
Joined: Tue Apr 16, 2019 9:23 am
Contact:

Re: Fresh Raspbian Image Start-up

Post by Realizator »

Hi RoggieC,
If SLP works fine, then hardware part is Ok. Let's check some settings.
I have a few things to check on the top of my mind:
1. Please check you enabled the cameras in the fresh Raspberry OS install. This can be done over GIU, or from the terminal (sudo raspi-config).
2. The file in our Wiki is archived (zip). Please unzip it before the placing to BOOT
Eugene a.k.a. Realizator

RoggieC
Posts: 2
Joined: Wed Jun 23, 2021 10:11 pm

Re: Fresh Raspbian Image Start-up

Post by RoggieC »

Hello Realizator,

Thank you for the last suggestion; however, we still appear to be receiving the same error code after making those changes. After attempting to install a new raspberry pi OS, we are not able to find the “stereopi.conf” file which may be affecting this. Are you aware of where this file could be located or how it could be replaced?

Thank you,
Attachments
Error Code
Error Code
EE7375CE-A108-4E00-8B6A-6AE77C1986E2.jpeg (3.99 MiB) Viewed 88 times

Post Reply