stereoPi upgraded case

Cases, camera mount mechanics, 3D printing, laser cut etc.
Post Reply
NiamoR42
Posts: 4
Joined: Wed May 22, 2019 8:17 pm

stereoPi upgraded case

Post by NiamoR42 » Wed May 22, 2019 8:31 pm

Hello,

perhaps it could help you : I did some modifications on the current stereoPi case.
you can find the cad and freecad project here : https://www.thingiverse.com/thing:3633970

Image

I remove these volumes on the current design :
Image
Image

result (I have to improve my 3D printer...) :
Image
Image

You are able to use screw & bolt to fix the card =)
Image
NiamoR42

User avatar
Realizator
Site Admin
Posts: 135
Joined: Tue Apr 16, 2019 9:23 am
Contact:

Re: stereoPi upgraded case

Post by Realizator » Thu May 23, 2019 9:49 am

NiamoR42, wow, that's great, thank you for sharing!
By the way, are you planning to add vent holes at the bottom, or you have no temperature issues? Are you using CM3 or CM3+?
Eugene a.k.a. Realizator

NiamoR42
Posts: 4
Joined: Wed May 22, 2019 8:17 pm

Re: stereoPi upgraded case

Post by NiamoR42 » Thu May 23, 2019 11:10 am

Realizator wrote:
Thu May 23, 2019 9:49 am
NiamoR42, wow, that's great, thank you for sharing!
By the way, are you planning to add vent holes at the bottom, or you have no temperature issues? Are you using CM3 or CM3+?
why not, I'll see it by using the stereoPI.
it's true that the glue gun was good but, with the temperature, the cover takeoff. I may need to use others screw.

Post Reply